ARAG Skipper LT - Functions List; F1 New Job

45
8.4 FunctionsList:PAGE4
8.4.1
F1Newjob
Start a new spraying job (Fig. 132)
Fig. 132
Fig. 133
Fig. 134
Fig. 135
Fig. 136
1 Press
F1 to start a new spraying job.
Conrmation prompt is displayed to start procedure.
2 Press OK.
Skipper LT requests you to save job you were carrying out before starting the
procedure. Press
OK (3A) or ESC (3B):
3A
OK allows you to save job: enter a name (Fig. 134).
Type in name as described under par. 6.3 - Using the programming keys.
3B
ESC lets you go to machine selection page (Fig. 135) without saving job:
workdatadisplayedsofarwillbelost.
4 Press keys to select the "machine"* in use among the listed ones.
5 Press
OK to conrm machine selection.
Drive and perform the job. (Fig. 136)
* "machine": includes all settings you set up during Skipper LT programming (chapt. 6.5), concerning tractor you will use for the job.
For instance, you could use Skipper LT with many machines so to obtain the correct information you shall recall the features of the machine in use.
WORK FUNCTIONS - PAGE 4