What to do if the ARAG GPS display does not switch on?
If the ARAG GPS display doesn't switch on, there could be a couple of reasons. First, check the power supply connection. Second, ensure the monitor is turned on by pressing the ON key.
How to fix ARAG GPS display when it does not switch on?
If the ARAG GPS display doesn't switch on, it might be due to no power supply. Check the power supply connection. Alternatively, the computer might be OFF. Try pressing the ON key.
What to do if ARAG GPS cannot reach the output volume value set for automatic operation?
If you're unable to reach the output volume value set for automatic operation with your ARAG GPS, it could be due to a wrong setup. Check the spray rate setup and the setup of the boom width. Another cause might be that the system is not adequately sized to provide the required rate, so check the maximum pressure valve adjustment and ensure the control valve is adequate for the specific system. A control valve malfunction could also be the reason; in that case, check the valve operation.
Why instantaneous pressure is not displayed on ARAG GPS?
If the instantaneous pressure is not displayed on your ARAG GPS, the issue could stem from a wrong setup. Check the pressure sensor setting. It's also possible that the computer isn't receiving signals from the pressure sensor, or that the pressure sensor is wrongly installed; in both cases, check the connections to the pressure sensor.
What to do if instantaneous pressure readout is inaccurate on ARAG GPS?
If the instantaneous pressure readout is inaccurate on your ARAG GPS, it could be due to a wrong setup. Check the full scale setup for the pressure sensor. Another cause might be that the pressure sensor is not calibrated; in this case, perform the calibration. Also, check the connections to the pressure sensor, as the pressure sensor might be wrongly installed.
Why sprayed fluid count displayed on ARAG GPS does not match liters/gal actually sprayed?
If the sprayed fluid count displayed on your ARAG GPS does not match the actual liters/gal sprayed, it's likely due to a wrong setup. Check the setup of the flowmeter constant and the selected nozzle configuration.
Why distance traveled count displayed on ARAG GPS does not match actual distance covered?
If the distance traveled count displayed on your ARAG GPS doesn't match the actual distance covered, the issue is likely due to a wrong setup. Check the boom setup, implement geometry, and tractor geometry.
What to do if RPM value is not displayed on ARAG GPS?
If the RPM value is not displayed on your ARAG GPS, it may be because the monitor is not receiving signals from the RPM sensor, or the RPM sensor is wrongly installed. In both cases, check the connections to the RPM sensor.
Why output volume readout is inaccurate on ARAG GPS?
If the output volume readout is inaccurate on your ARAG GPS, it's likely due to a wrong setup. You should check the boom setup, the setup of the flowmeter constant and the pressure sensor full scale setting.
Why is the RPM readout inaccurate on ARAG GPS?
If the RPM readout is inaccurate on your ARAG GPS, it is likely due to a wrong setup. Check the RPM sensor constant setting.
To Next Page
General
