70
SELETRON REPLACEMENT
11.1 Preliminary Operations
TO AVOID ACCIDENTS, EMPTY THE TANK AND MAKE SURE THAT THE ENTIRE SYSTEM IS COMPLETELY
FREE FROM CHEMICALS.
IMPORTANT: Set the main switch and section switch to ON. Enable all nozzles and disable all automatic functions
par. "13 Automatic functions" on page 78.
control ON
+
Open
sections
+
Enabled
nozzles
+
MANUAL nozzle
selection settings
+
MANUAL section
management settings
Fig. 235
11.2 Seletron replacement
Fig. 236
Correctly paired Seletron
NOT correctly paired Seletron
- ONLY DISCONNECT THE SELETRON DEVICES THAT WERE NOT CORRECTLY PAIRED (
Fig. 236).
CONTINUES > > >
ADVANCED SETUP "DEVICE STATUS"
To Next Page
Loading...
