ARAG Skipper LT - Memories Management; Internal Memory

23
6.6 Memoriesmanagement
Fig. 53
Allows you to load, save and/or delete information stored on Skipper LT or on a remote memory (pendrive); this
data concern jobs done or machine congurations.
The possible operations will be explained in the paragraphs below.
PreparingthePendrivefordataexchange:refertopar.6.6.4.
6.6.1 - Internal memory
Fig. 54
Copy files to Pendrive
Allows you to transfer saved data, about jobs, from Skipper LT internal memory to a pendrive.
TodisplaythemenuitemsitisnecessarytoconnectthependrivetoSkipperLTusingthesuitableconnector(par.5.4).
Ifconnectionisnotmade,themessage
Pendrive not found! isdisplayed.
• Copy jobs to Pendrive
Fig. 55 Fig. 56
1 Select i
tem Copy jobs to Pendrive (Fig. 55) and press
OK;
2 Scroll the jobs list (Fig. 56) using keys + or - and select
the le to copy;
3 Conrm copy by pressing
OK.
A conrmation message is displayed once copy is completed
(Fig. 57). Press
ESC.
Fig. 57
ERROR MESSAGES
Fig. 58
The pendrive already contains a le with this name.
Following are the two possible instances:
- Press
OK to replace le.
WARNING:ALLdataconcerningreplacedlewillbelost.
- Press
ESC to avoid replacing the le: check le content or change name before repeating save option.
Fig. 59
Possiblecauses:
- Space available on pendrive is over: eliminate some les from pendrive as explained under
par. 6.6.2
Pendrive / Delete Pendrive files and try saving again.
- The pendrive is locked: unlock and repeat saving.
PROGRAMMING - MEMORIES MANAGEMENT
Par.
6.3
Scrolling menu items.
Increase / decrease data
Quit the function or
data changes
Conrm access or
data changes.
Shift the
cursor
Reset / disable
data