116 Operation of The Camera
The cameras will automatically negotiate IP addresses. After about 5
seconds, connections are established.
The master camera will initially distribute its settings to the slave camera.
Once this is done, settings can also be changed on the slave camera, and
the change will take effect on both cameras. This is useful if the master
camera's controls are not accessible.
If a camera is set to ETH master or ETH slave, but is not connected to
another camera, a warning is emitted on the STATUS Info screen.
Synced settings
This is a list of all settings that are affected by the sync:
WB>White Balance + CC Tint
EI> Exposure Index
FPS> Sensor FPS
SHUTTER> Shutter Angle
COLOR>Gamma>SxS
COLOR>Gamma>REC OUT
COLOR>Gamma>MON OUT
COLOR>Gamma>REC OUT
COLOR>Gamma>EVF
COLOR>Gamma>LOG C film matrix
MENU>Recording>SxS>SxS Recording
MENU>Recording>SxS>SxS Codec
MENU>Recording>SxS>Dual recording
MENU>Recording>REC OUT>Frame rate
MENU>Recording>REC OUT>HD-SDI format
MENU>Recording>REC OUT>Scan format
MENU>Recording>REC OUT>Output range
MENU>Recording>REC OUT>REC OUT fps sets sensor fps
MENU>Recording>REC OUT>SDI remote
MENU>Recording>REC OUT>Vari flag
MENU>Monitoring>EVF>Status info
MENU>Monitoring>EVF>Surround view
To Next Page
Loading...
