Plus Camera Controls 131
Shows status, direction and torque of the CLM connected to the FOCUS
socket.
Press the FOCUS CLM screen button to access the focus CLM screen. This
screen shows the type of motor connected to the FOCUS socket, its
direction and torque. Direction and torque can be changed by the screen
buttons below and above the value. The upper left screen button calibrates
only the focus motor.
Pressing the lower left screen button starts calibration of all connected lens
motors.
3D Lens Sync
When two cameras are connected and their sensors are synced with via the
EXT connectors, the slave camera will receive its motor commands from the
master camera. Its radio module switches automatically off. Calibration of
lens motors must happen individually for each camera.
To Next Page
Loading...
