TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
5
1 Use a screwdriver or similar and release the cover by applying a light pressure to the
two snap catches (1) and remove the cover (2).
2 The plastic partition is scored to facilitate breaking at convenient intervals. Use
pliers to break off a suitable section.
3 Run the wiring out through the partition. Wiring can be run three ways from the
module:
• Remove the rectangular covers and run the cabling out through the side (1).
• Break off sections at short side of case and run the cabling downwards (2).
• Run the cabling through the round holes at the bottom of the case (3).
4 Secure the wiring with cable straps.
Figure 3.
Figure 4.
Figure 5.
1
1
2
002
003
2
1
2
3
1
3
004
To Next Page
Loading...