TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
30
4.7.3 Administer Fault Log
In the Administer Fault Log page, it is possible to export the log file to CSV (Comma
Separated Values) file format, and to clear the status log file from non-active faults. A
timeout can be set to block repeated Status Logs i.e. the fault will be discarded and no
actions will be executed.
1 Click “Configuration” on the start page.
2 Select Other Settings > Administer Fault Log in the left menu on the UPAC
Configuration page to open the page.
Export Fault Log
1 Click “Export”.
2 Click “Save” in the dialogue window and enter the file name (default name
statuslog.csv) and the file path.
Clear Fault Log
1 Click “Clear”.
2 Click “Yes” in the dialogue window to remove all non-active faults from the status
log file.
Timeout
1 Enter the timeout in minutes (0-1000 minutes), the default value is 10 minutes.
If no Status Logs should be blocked, set the timeout to 0.
2 Click “Set timeout” to save the setting.
4.7.4 Site Information
In the Site Information page, it is possible to export information about the site to a text
file. The text file can be used for support purposes. Information about the modules and
the supervised equipment will be included in the text file as well as the last 100 status
logs.
1 Click “Configuration” on the start page.
2 Select Status > Site Information in the left menu on the UPAC Configuration page
to open the page.
Figure 48.
To Next Page
Loading...
Need help?
General
