TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
7
2.5 Function LED Indications
The function indicator shows the UPAC status (LED1 on the circuit board). For the
placement of LED1, refer to the illustration in figure 45 on page 26.
The table below shows which indication refers to which status.
2.6 Information required for the Setup
Make sure the following information is available:
• MAC address – found on the licence certificate enclosed in delivery
• Licence number – found on the licence certificate enclosed in delivery
• Network parameters – ask your network administrator
• Type of connected wireless phone system
• IP address to connected system (if connected via IP)
• Other messaging systems to send messages to (optional)
• IP address to mail server if fault information and Activity Logs are to be sent to e-mail
recipients (optional)
• LDAP properties if an LDAP server is used (optional)
Figure 8.
1
Fail safe mode is indicated, even if SW3 pin 2 is not set to ON, if the application on UPAC is not completely
installed or when the application part of the Compact Flash is erased.
2
When UPAC is in Network setup mode, this will always be indicated and override LED indications of other
simultaneously activated modes, for example Image installation mode.
3
Starting up mode is indicated during start of applications or if an application has lost connection to a
required resource, for example DECT Exchange.
Status
Colour
Green
Orange
OK. Running
Fail-safe mode
1
Network setup mode
2
LED Indication
Red
Orange
Orange
Orange
Orange
Red
Red
Red
Red
Red
Starting up
3
Orange
Image installation mode
Power up
Restart
Halted (auto. restart after 10 min.)
Unlicensed mode
Low voltage
Licence error
Watch-dog reset
Shut-down
Memory error (3 s ON / 3 s OFF)
Network error (IP interface initiation error)
Module key error (Module key not found)
Each segment = 100 ms
007
To Next Page
Loading...
Need help?
General
