ASCOM UPAC Series User Manual

TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
27
4.6.3 Add Locations
Note: Requires UPAC Security Pack (UPAC-LSP) licence.
IMPORTANT: Do not mix the two location types DECT location and Base Station location
in one system.
IMPORTANT: When UPAC Alarm Handling triggers on "Alarm trigger" the included
location in a text message action can be faulty because DECT location is
prioritized higher then Base Station location. That is if a handset has
received a DECT location in one area and the user sends an alarm from
another area with only Base Station locations, the location that will be
included in the message text is the DECT location that could be very old
and no longer valid.
1 Select Alarm Handling > Locations and click “Add”.
2 Enter the code for the location in the Code text field.
Tip: To get the code for the location: 1) select alarm trigger, 2) create a message
action, 3) click “Reply to sender” icon to send the message to the sender of the
alarm, 4) insert [location] in the message text, 5) trigger an alarm. You will receive
the code in the display.
3 Enter a short description of the location in the Description text field. Click “Save”.
When setting up the alarm action this description can be included in the message
text.
4.7 Status
4.7.1 Active Faults
Active Faults page is where all persistent fault logs are listed. For more information about
the fault log, refer to 4.7.2 Fault Log on page 28.
1 Click “Configuration” on the start page.
2 Select Status > Active Faults in the left menu on the UPAC Configuration page to
open the page.
The following information is shown for each fault:
• Time when the fault occurred
• Level of the fault:
- Critical error
-Error
-Warning
• Description of the fault, as defined in the module
• Type of module
• IP address and host name of the module that generated the fault
By expanding the fault in the list, additional information about the fault is shown
containing:
• Fault ID
This is used to reference a persistent fault when it later is reset
•Fault code
• Description of the fault code

ASCOM UPAC Series Specifications

General

Brand	ASCOM
Model	UPAC Series
Category	Conference System
Language	English