TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
26
• Output Action
1 Select which output to activate in the Output drop-down list. Only outputs defined
in the I/O Setup are available. Refer to 4.5 Input/Output Setup on page 18.
2 Enter (in seconds) for how long the output shall be activated in the Duration text
field.
Select Escalation Action
If the Request confirmation checkbox is checked and the message has not been
confirmed within the specified time, it can be escalated to another action which in
turn can be escalated. Up to three escalations are possible for each triggered alarm
action.
Note: If the input trigger is repeated make sure the Repetition Time, see • Input
Trigger on page 24, is longer than the complete escalation chain. This is advised to
avoid confusing the users with several simultaneous escalation chains for the same
trigger".
1 Enter (in seconds) for how long UPAC shall wait before escalation.
2 Select action to take in the Escalation drop-down list and click “Add”.
• For Message action refer to • Message Action on page 25.
• For Output action refer to • Output Action on page 26.
3 Click “Save”.
Figure 44.
Figure 45.
To Next Page
Loading...
Need help?
General
