EFD1000 Installation Manual
DOCUMENT # A-01-126-00 PAGE 164-225 Revision H
© Copyright 2009 Aspen Avionics Inc.
With the HDG Bug centered, press the GPSS button again and verify the HDG Bug
controls the autopilot as before.
h) Perform an ILS approach using VLOC1 (ILS1 source indication). Verify that the
autopilot tracks the localizer, then captures and tracks the glideslope if installed.
i) Now repeat with ILS2 if installed.
j) If your GPS supports GPS WAAS LPV approaches, perform an LPV approach using
GPS1. Verify that the autopilot tracks the GPS lateral approach guidance, then
captures and tracks the GPS LPV vertical guidance.
k) Repeat with GPS2, if installed.
This completes the flight test. If everything was satisfactory then document the completion of the
Test Flight in aircraft log book in accordance with FAR 91.407(b).
To Next Page
