EFD1000 Installation Manual
DOCUMENT # A-01-126-00 PAGE 43-225 Revision H
© Copyright 2009 Aspen Avionics Inc.
NOTE: The Bendix/King KTA810/910 and KMH820/920 only accept High Speed
A429 heading and therefore are not compatible with this output. Contact
Aspen Avionics product support for suggestions on using an ARINC 429
low to high speed converter.
5.6.7 Second ACU
A second ACU is required when two (2) analog VLOC receivers are installed.
5.6.8 Flush or Recess Mounting the PFD
If there is insufficient clearance between the PFD and control column when the flight
controls are in the full nose down position, it will be required to flush mount or recess
mount the PFD in the instrument panel. Also the installer may choose to flush mount
the PFD for cosmetic reasons. In either case, flush mounting of the PFD is beyond the
scope of this manual and will require that the brackets be locally fabricated and the
instrument panel modification be separately approved.
To Next Page
Loading...
