EFD1000 Installation Manual
DOCUMENT # A-01-126-00 PAGE 4-225 Revision H
© Copyright 2009 Aspen Avionics Inc.
The conditions and tests required for TSO approval of the EFD1000 System are minimum
performance standards. It is the responsibility of those installing this article either on or within
specific type or class of aircraft to determine that the aircraft installation conditions are within
the TSO standards. TSO articles must have separate approval for installation in an aircraft. The
article may be installed only if performed under 14 CFR Part 43 or the applicable airworthiness
requirements.
This manual contains FAA Approved installation instructions for installation of the Aspen™
EFD1000 system under the EFD1000 AML STC for use as a primary electronic flight display
during day/night IFR and VFR operations in those Part 23 Class I and II aircraft (as defined in AC
23.1309-1C) listed on the EFD1000 AML. Installation of the EFD1000 into US-registered 14CFR
Part 23 Class I or II aircraft not included in the EFD1000 AML, Part 23 class III or IV aircraft, any
part 25, 27, or 29 aircraft, or non-U.S. registered aircraft requires separate airworthiness
approval.
To Next Page
Loading...
