EFD1000 Installation Manual
DOCUMENT # A-01-126-00 PAGE 71-225 Revision H
© Copyright 2009 Aspen Avionics Inc.
Metal Clamper
Qty 7 – 22 AWG conductors
Screw
10mm
4mm
To
PFD
Hood
Metal
Cover
Connector
To
RSM
20mm
M27500-22TG7T14 or
M27500-A24SD7T23 or equivalent
Figure 7.3 – RSM Connector assembly
CAUTION: Do not run RSM wiring near high current devices such as strobes and air
conditioners and avoid running RSM wiring in same wire bundle as strobe
and air conditioning wiring bundles if at all practical.
PFD END
Terminate the shield at the PFD end inside the back shell. Attach pigtail ground wire to
shield and connect to ground screw as shown in Figure 7.4.
Figure 7.4 – PFD Back Shell Grounds/RSM
To Next Page
Loading...
