13
Checking the Installation Location
Install the product on a level gantry located on a sturdy, level floor.
For the installation, choose a sturdy, level floor with no bumps. If the product is installed in a
bumpy place or not horizontally, the installation of the product becomes unstable and
malfunction or personal injury can result.
When installing, do not drag the product.
The adjusters of the product are fitted with antivibration rubber to reduce vibration. If the
product is hauled, the antivibration rubber can be damaged. Therefore, be sure to lift and carry
the product.
Location not directly exposed to sunlight
Avoid locations directly exposed to sunlight. If the product is kept running at a location directly
exposed to sunlight, the originally intended performance of the product may not be recognized.
Location away from heat sources
Avoid locations near large heat sources such as a heater, boiler, oven, and autoclave. The
originally intended performance of the product may not be recognized.
Location whose ambient temperature is in the range from 24ºC to 28ºC
If the ambient temperature is too high or too low, the originally intended performance of the
product may not be recognized.
Sufficient empty space needs to be kept around the product.
Each space adjacent to the sides and rear of the product must be 100 mm in length at least.
Location with low humidity
Choose a location where humidity is 80% RH or less. If the product is used in a humid place,
short circuit or electric shock may result.
Location without flammable gas and corrosive gas
Do not install in a location exposed to flammable gas or corrosive gas. Explosion or fire may
occur. Also, corrosion of the electric components induces deterioration of the insulation and
causes short circuit or electric shock.
Location not exposed to falling objects
Avoid a place where objects may fall on the product. Product damage and malfunction may
result.
Warning: Do not use outdoors. If the product is used in a place which can be exposed to
rainwater, short circuit or electric shock may result. Do not install in a humid
place or place that can be exposed to water, for example, near a sink or water
tap. Also, avoid a place above which piping for water supply and a sink is
present. Deterioration of the insulation may cause short circuit or electric shock.
To Next Page
Loading...
Need help?
General
