16
Setting Dishes
For this product, only µDrop GPS Dish are usable.
1. Set culture dish to dish holder.
Position the culture dish so that the alignment projection on the bottom of the dish fits into the
notch of the dish holder, shown in figure 1.
If this alignment is inappropriate, capture misalignment can occur at the time of image capture.
2. Open the lid of the target incubation chamber while pushing the unlock tab, and then position
the dish holder into the chamber so that it fits into the frame at the bottom of the chamber.
(Figures 2 and 3)
3. Gently close the lid until the latch sounds.
Each lid must be opened and closed gently. Losing hold of a lid when opening or closing
it can cause vibration and may adversely affect the cultivation of fertilized eggs, for
example.
To Next Page
Loading...
