For the setting items, DOWN key , UP key , SILENCE key , and SET key
are to be used for making settings.
[Setting mode]
Press and hold SET for 1 second or longer to move to the setting mode. The setting mode allows to
make settings for temperature, CO
2
, and O
2
. If no operations are performed for about 10 seconds in
the setting mode, the normal display mode is restored.
On this product, temperature control is performed
for each incubation chamber.
Each setting and fine adjustment can also be performed
for each chamber.
In this instruction manual, numbers are assigned to the
individual incubation chambers as shown to the right,
and the chambers are referred to as "incubation chamber
1" to "incubation chamber 9" or "ch 1" to "ch 9".
To Next Page
Loading...
Need help?
General
