Ch. 21. Shipping or Moving Sec. 21.4. Shipping a Complete Cypher AFM System
d)
2 screws need to go in the bottom back
using 1/8” Hex Wrench L-key
(part#290.119). Include a nut on each
screw. The nut sits between the mullet and
the chassis. Tighten to the point where it is
flush with the mullet metal. Don’t bend the
metal visibly.
e)
Now turn the nut back toward the screw
head and tighten it with pliers (Pliers not
provided with system) – one on each side.
(SCREW INFO: 10-32 x1 ½ or1 ¾ BHCS
SS depending on which guard you have &
2 10-32 Kepnuts.)
9.
Once guard is on, lift the chassis with the side
handles and place it into the bottom foam/box
carefully. NOTE: HEAVY, ABOUT 51 LBS.
10. Place a plastic bag around the chassis once it is in the foam.
11. Place the top foam atop the chassis.
12. Place the 1/8” Hex Wrench L-key in the foam cut-out or tape it to the top foam.
13. Close the box and tape it shut.
BETA
Page 259
To Next Page
Loading...