Ch. 12. Cantilever Holder Guide Sec. 12.2. Disassembly
12.2. Disassembly
Only the cantilever clip can be removed from the cantilever holder. All other parts should not be removed
or serviced by the user.
12.2.1. Removing the Clip
1.
Remove the screw:
• Using a small phillips screwdriver,
simply unscrew the screw completely.
2.
The clip:
• The clip should come off as shown.
• Spare screws and O-rings can be found
in the parts kit (see Section 10.1 on
page 115).
12.2.2. Attaching the clip
1.
Cantilever holder:
• The Cantilever holder should be sitting
ready without a clip, as shown.
DRAFT
Page 143
To Next Page
Loading...