Chapter 4 – Functions of the instrument
UM-22100H-U User manual ATEQ D520 Page 99/122
5. RESULTS MENU
This function allows:
9 the display of the test result details: number of parts tested, number of good parts,
number of bad reference parts, number of bad test parts, number of recoverable
parts, number of times when the alarm has been set off (each indicator is expressed
in %),
9 to reset to naught the results memory,
9 to print the test results (number of good parts, number of bad parts).
6. LANGUAGE MENU
This function allows the choosing of the instrument language. Several languages are
available. Two are installed at the fabrication of the instrument. The English is the
language by default the other is chosen by the customer.
7. STAND-BY MENU
This function allows the switching off of the instrument without unplugging it from the
mains power supply. The switching to stand-by can be immediate or programmed with
hours of operation and hours of rest.
The immediate switching to stand-by can be carried out in two different ways:
1) Either through the Stand-by menu,
2) Or by pressing for more than three seconds on the RESET button
Note: when the instrument is
on stand-by the display is
switched off and only the
yellow indicator emits flashes
about every 3 seconds.
T
R
To reactivate the instrument
just press on any of the front
panel keys.
To Next Page
Loading...
