ATEQ D520 - Standby Using the Menu

Chapter 4 – Functions of the instrument
UM-22100H-U User manual ATEQ D520 Page 100/122
7.1. STANDBY USING THE MENU
Standby using the menu enables start and stop times for the instrument to be
programmed.
In the main menu, position the
cursor beside STANDBY and
confirm by pressing ENTER.
MAIN
MENU
RESULTS
LANGUAGE : English
STAND-BY
To program automatic standby
at a given time, position the
cursor beside STOP TIME.
STAND
-
BY
Now :No
Pow-on time :No
Pow-off time :No
Confirm the STOP TIME
parameter using YES
STAND
-
BY
Now :No
Pow-on time :No
Pow-off time :Yes
Then set parameters for the
time (hours and minutes)
when the standby must take
effect. "TIME DELAY" is the
delay (in minutes) between
the programmed time and
actual standby
STAND
/
P
ow
-
off
t
i
me
HOUR : 00
MINUTE : 00
Delay : 00
To program the start-up time
for the instrument, position the
cursor beside START TIME
STAND
-
BY
Now :No
Pow-on time :Yes
Pow-off time :Yes
Confirm the START TIME
parameter using YES
STAND
-
BY
Now :No
Pow-on time :Yes
Pow-off time :Yes
Then set parameters for the
instrument start time (in hours
and minutes).
STAND
/
P
ow
-
o
n
t
i
me
HOUR : 00
MINUTE : 00