ATEQ D520 - Copying a Test Program

Chapter 3 – Start-up and adjustments
UM-22100H-U User manual ATEQ D520 Page 40/122
3. COPYING A TEST PROGRAM
To be able to modify the
parameters, place the key in
the ACCESS position.
From the main menu, place
the cursor in front of the
PARAMETERS heading.
MAIN
MENU
RUN PROG. : 001
PARAMETERS
SPE CYCLE: Disabled
Validate with the ENTER key.
The cursor will place itself in
front of the Copy-Paste
function. Confirm this function
again with the ENTER key.
PARAMET
E
RS
Copy-Paste
Pr :001 VALVE 1
Pr :002 VALVE 2
Next, validate the COPY
function.
PARAM/C
o
py
-
P
as
t
e
COPY :Pr ---
PASTE :Pr ---
Display the number of the
program to be copied by using
the navigation arrows.
(Here, program n°1).
PARAM/C
o
py
-
P
as
t
e
COPY :Pr 001
PASTE :Pr ---
Confirm with the ENTER key.
PARAM/C
o
py
-
P
as
t
e
COPY :
P
r
001
PASTE :Pr ---
Place the cursor in front of
Paste.
PARAM/C
o
py
-
P
as
t
e
COPY :
P
r
001
PASTE :Pr ---
Confirm with the ENTER key.
Attribute a number to this new
program by using the
navigation keys (for example
n°3).
PARAM/C
o
py
-
P
as
t
e
COPY :Pr 001
PASTE :Pr 003
Confirm with the ENTER key.
The display confirms the copy
of the program.
COPY IN PROGRESS...