Chapter 5 - Accessories
UM-22100H-U User manual ATEQ D520 Page 105/122
2.5. REMOTE CONTROLS
The remote control allows control and selection of various settings remotely for
instruments in the ATEQ range. The remote is to be connected on the Input/Output
connector.
2.5.1. Reset/Start casing
Télémécanique
TLC
2.5.2. Four functions S5 remote control
This remote control has four functions which can be
used to control a series 5 instrument remotely.
(F580 or C540 single head only).
The four functions on this remote control are as
follows :
9 RESET and start cycle.
9 Increase or decrease program numbers.
9 Display the number of the program selected.
9 Display the test result, green indicator light
for Pass, red indicator light for Fail or alarm.
Note: a program number can only be changed
(increase or decrease) when no test cycle is
running.
TLC S5
88
www.ateq.com
2.5.2. 1) Connection details
J3
D520
TLC RC5
L = 3,5 m +/- 0,20 m
To Next Page
Loading...
