ATEQ D520 - 6. STARTING A MEASUREMENT CYCLE

Chapter 3 – Start-up and adjustments
UM-22100H-U User manual ATEQ D520 Page 45/122
6. STARTING A MEASUREMENT CYCLE
Press the START key to start
a measurement cycle.
RUN/P
r:
004
PRESS =0.500 bar
READY
The cycle phases are
displayed on the LCD window:
COUPL.,
FILL,
STAB,
TEST.
RUN/P
r:
004
PRESS =1.00 bar
STABILISATION
7. STOPPING A CYCLE
Press the RESET key to stop
the measurement. The display
“READY” indicates that the
instrument is ready to perform
a new measurement test.
RUN/P
r:
004
PRESS =0.500 bar
READY