ATEQ D520 - 5. LAUNCHING A MEASUREMENT CYCLE

Chapter 3 – Start-up and adjustments
UM-22100H-U User manual ATEQ D520 Page 43/122
5. LAUNCHING OF A CYCLE
5.1. CHOICE OF THE PROGRAM NUMBER TO BE LAUNCHED
Position the key in the
ACCESS position.
Starting from the main menu,
place the cursor in front of the
RUN PROG. function.
MAIN
MENU
RUN PROG.: 001
PARAMETERS
SPE CYCLE :Disabled
Confirm with the ENTER key.
MAIN
MENU
RUN PROG.: 001
PARAMETERS
SPE CYCLE :Disabled
Display the number of the
program required by scrolling
through the numbers with the
navigation keys.
MAIN
MENU
RUN PROG. : 004
PARAMETERS
SPE CYCLE :Disabled
Confirm your choice with the
ENTER key.
MAIN MENU
RUN PROG. : 004
PARAMETERS
SPE CYCLE :Disabled