Atlas Copco FlexiROC T30 R

FlexiROC T30 R 3 Controls and Instrument
26 No: 2969809547.1.2969824267 en-US
!
NOTE: Only set high percussion pressure when high percussion is used.
The pressure information is measured by a pressure transducer, and the lower value is the
desired PWM current for Y100. Can only be used when the function is used. Adjust desired
current with arrow up and down.
!
NOTE: Only set high feed pressure when high feed is used.
The pressure information is measured by a pressure transducer, and the lower value is the
desired PWM current for Y103. Can only be used when the function is used. Adjust desired
current with arrow up and down.
Setting the rotation speed. Pressure is only read during rotary drilling. Adjust desired cur-
rent with arrow up and down.