Atlas Copco FlexiROC T30 R - Page 91

FlexiROC T30 R 4 Operation
91 No: 2969809547.1.2969824267 en-US
1.
Lock the coupling sleeve, close the drill rod support.
2.
Move the right multi-function lever (E) into threading position (H) to disconnect the
rock drill from the drill rods.
3.
Move the right multi-function lever into position (C) to move the rock drill back.
4.
Move left multi-function lever (A) in position (C) to move the drill rods into drill center.
5.
Move left multi-function lever to sector (C) to obtain hard grip.
6.
Move right multi-function lever to sector (G) to thread the drill rods into the rock drill.
7.
Move left multi-function lever to neutral position to obtain loose grip.
8.
Move right multi-function lever to sector (G) (threading) until both joints are tightened.
9.
Move right multi-function lever to sector (E) to open the claws.
10.
Move left multi-function lever to sector (A) to move back the rod handling arms.