Version 5.2 103 September 2007
SIP User's Manual 5. Web-based Management
5.5.2.1 General Parameters
The General Parameters option is used to configure general control protocol parameters.
¾ To configure the advanced general protocol parameters, take
these 4 steps:
1. Open the 'General Parameters' screen (Protocol Management menu > Advanced
Parameters submenu > General Parameters option).
2. Configure the parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to 'Saving Configuration' on page 256.
To Next Page
Loading...