Version 5.2 241 September 2007
SIP User's Manual 5. Web-based Management
Notes:
• When you activate the wizard, the rest of the Embedded Web Server
interface is unavailable and the background Web screen is disabled.
After the process is completed, access to the full Embedded Web Server
is restored.
• The wizard allows you to load an ini or auxiliary file only after you have
loaded a CMP file.
¾ To use the Software Upgrade Wizard, take these 10 steps:
1. Stop all traffic on the gateway (refer to the note above).
2. Open the 'Software Upgrade Wizard' (Software Update menu > Software Upgrade
Wizard); the 'Start Software Upgrade' screen appears.
Figure 5-60: Start Software Upgrade Wizard Screen
Note: At this stage, the Software Upgrade Wizard can be canceled (by clicking
Cancel), without requiring a gateway reset. However, if you continue the
wizard (by clicking the Start Software Upgrade button), the process must be
followed through and completed with a gateway reset. If you click the Cancel
button in any of the subsequent screens, the gateway is automatically reset
with the configuration that was previously burned in flash memory.
3. Click the Start Software Upgrade button; the 'Load a cmp file' screen appears.
To Next Page
Loading...
Need help?
General