EasyManuals Logo

AudioCodes Mediant 2000 System User Manual

AudioCodes Mediant 2000 System
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #133 background imageLoading...
Page #133 background image
Version 5.2 133 September 2007
SIP User's Manual 5. Web-based Management
Use the Profile Definitions submenu to configure profiles:
îš„ Coder Group Settings (refer to 'Coder Group Settings' on page 133)
îš„ Tel Profile Settings (refer to 'Tel Profile Settings' on page 134)
îš„ IP Profile Settings (refer to 'IP Profile Settings' on page 136)
Note: The default values of the parameters in the Tel and IP Profiles are identical to
the Embedded Web Server/ini file parameter values. If a value of a parameter
is changed in the Embedded Web Server/ini file, it is automatically updated in
the Profiles correspondingly. After any parameter in the Profile is modified by
the user, modifications to parameters in the Embedded Web Server/ini file no
longer impact that Profile.
5.5.5.1 Coder Group Settings
The Coder Group Settings option is used to define up to four different coder groups.
These coder groups are used in the 'Tel Profile Settings' and 'IP Profile Settings' screens to
assign different coders to Profiles.
For each coder group you can define up to five coders, where the first coder (and its
attributes) in the list takes precedence over the second coder, and so on. The first coder is
the highest priority coder and is used by the gateway whenever possible. If the far end
gateway cannot use the coder assigned as the first coder, the gateway attempts to use the
next coder and so forth. For a list of coders supported by the gateway, refer to 'Coders' on
page 96.
You can also configure the coder groups using the ini file parameter CoderName' (refer to
SIP Configuration ' on page 295Parameters).
¾ To configure coder groups, take these 11 steps:
1. Open the 'Coder Group Settings' screen (Protocol Management menu > Profile
Definitions submenu > Coder Group Settings option).
Figure 5-22: Coder Group Settings Screen

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant 2000 System and is the answer not in the manual?

AudioCodes Mediant 2000 System Specifications

General IconGeneral
BrandAudioCodes
ModelMediant 2000 System
CategoryVoIP
LanguageEnglish