SIP User's Manual 224 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
5.10.3 Configuring SNMP V3 Users
The 'SNMP V3 Setting' screen is used to configure authentication and privacy for up to 10
SNMP v3 users.
¾ To configure the SNMP v3 users, take the following 6 steps:
1. Access the 'Management Settings' screen (Advanced Configuration menu >
Management Settings); the 'Management Settings' screen is displayed.
2. Open the 'SNMP V3 Setting' screen by clicking the SNMP V3 Table arrow sign (-->).
Figure 5-47: SNMP V3 Setting Screen
3. To add an SNMP v3 user, in the 'New Row Index' field, type the desired row index,
and then click Add an Empty Row. A new row appears.
4. Configure the SNMP V3 Setting parameters according to the table below.
5. Click the Apply Row Settings button to save your changes.
6. To save the changes so they are available after a hardware reset or power fail, refer to
'Saving Configuration' on page 256.
Notes:
• To delete an SNMP V3 user, select the 'Index' radio button
corresponding to the SNMP V3 user that you want to delete, and then
click the Delete Row button.
• To copy an existing SNMP V3 user configuration to a new row, select the
radio button on the left of the desired SNMP V3 user, and then click
Copy Selected Row as A New Row. A new row appears that includes
the same configuration as the selected row.
• To sort all row indexes incrementally, click Compact Table.
Table 5-49: SNMP V3 Users Parameters
Parameter Description
Index
[SNMPUsers_Index]
This is the table index. Its valid range is 0 to 9.
Username
[SNMPUsers_Username]
Name of the SNMP v3 user. This name must be unique.
AuthProtocol
[SNMPUsers_AuthProtocol]
Authentication protocol to be used for the SNMP v3 user.
 0 = none (default)
 1 = MD5
 2 = SHA-1
To Next Page
Loading...
Need help?
General