Version 5.2 39 September 2007
SIP User's Manual 3. Installation
¾ To connect Mediant 2000 using a DC terminal block screw
connector, take these 3 steps:
1. Create a DC cable by inserting two 14-16 AWG insulated wires into the supplied
adaptor (refer to the figure below) and fasten the two screws, each one located
directly above each wire.
2. Connect the two insulated wires to the correct DC power supply. Ensure that the
connections to the DC power supply maintain the correct polarity.
3. Insert the terminal block into the DC inlet located on the Mediant 2000.
Figure 3-9: DC Power Terminal Block Screw Connector
¾ To connect Mediant 2000 using a DC terminal block crimp
connector, take these 3 steps:
1. Remove the DC adaptor (screw connection type) that is attached to the Mediant 2000
rear panel.
2. Connect the two insulated wires to the correct DC power supply. Ensure that the
connections to the DC power supply maintain the correct polarity (refer to the figure
below).
3. Insert the terminal block into the DC inlet located on the Mediant 2000.
Figure 3-10: DC Power Terminal Block Crimp Connector
To Next Page
Loading...
Need help?
General