SIP User's Manual 262 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
The Home page also displays general information in the 'General Information' pane. This
information includes parameters such as the gateway's IP address and firmware version.
5.14.2 Switching between Mediant 2000 Modules
The Mediant 2000 consists of up to two modules, as discussed in previous sections. The
graphical display of the Mediant 2000 displays only one of the modules to which you are
connected. However, you can easily and quickly switch to the second module. When you
do this, the Web browser connects to the IP address of the switched module.
¾ To switch modules, take these 3 steps:
1. On the Home page, click on any one of the ports of the module to which you want to
switch; a confirmation message box appears requesting you to confirm switching of
modules.
Figure 5-69: Confirmation Message Box for Switching Modules
2. Click OK; the 'Enter Network Password' screen pertaining to the Embedded Web
Server of the switched module appears.
3. Enter the login user name and password, and then click OK.
5.14.3 Viewing Ethernet Port Information
The Home page allows you to view the 'Ethernet Port Information' screen, which provides
read-only information on the Ethernet connection used by the gateway. Accessing this
screen from the Home page provides an alternative to accessing it from the Status &
Diagnostics menu (refer to 'Viewing Ethernet Port Information' on page 235).