AudioCodes Mediant 2000 System - Configuring the Digital Gateway Parameters

To Next Page

To Previous Page

SIP User's Manual 142 Document #: LTRT-68806

Mediant 2000 & TP-1610 & TP-260/UNI

5.5.8 Configuring the Digital Gateway Parameters

The 'Digital Gateway' screen is used to configure miscellaneous digital parameters.

¾ To configure the digital gateway parameters, take these 4 steps:

1. Open the 'Digital gateway Parameters' screen (Protocol Management menu >

Digital Gateway Parameters).

Figure 5-26: Digital Gateway Parameters Screen

2. Configure the Digital Gateway parameters according to the table below.

3. Click the Submit button to save your changes.

4. To save the changes to flash memory, refer to 'Saving Configuration' on page 256.