Version 5.2 107 September 2007
SIP User's Manual 5. Web-based Management
Table 5-12: General Parameters (Advanced Parameters)
Parameter Description
CDR Report Level
[CDRReportLevel]
Determines whether or not CDRs are sent to the Syslog server, and if
enabled, at which events they are sent.
Valid options include:
 [0] None = Call Detail Record (CDR) is not used
 [1] End Call = CDR is sent to the Syslog server at the end of each
call.
 [2] Start & End Call = CDR report is sent to Syslog at the start and
end of each call.
 [3] Connect & End Call = CDR report is sent to Syslog at connection
and at the end of each call.
 [4] Start & Connect & End Call = CDR report is sent to Syslog at the
start, at connection, and at the end of each call.
The CDR Syslog message complies with RFC 3161 and is identified by:
Facility = 17 (local1) and Severity = 6 (Informational).
Debug Level
[GwDebugLevel]
Syslog logging level. One of the following debug levels can be selected:
 [0] 0 = Debug is disabled (default)
 [1] 1 = Flow debugging is enabled
 [2] 2 = Flow and device interface debugging are enabled
 [3] 3 = Flow, device interface and stack interface debugging are
enabled
 [4] 4 = Flow, device interface, stack interface and session manager
debugging are enabled
 [5] 5 = Flow, device interface, stack interface, session manager and
device interface expanded debugging are enabled.
Note: Usually set to 5 if debug traces are needed.
Misc. Parameters
Progress Indicator to IP
[ProgressIndicator2IP]
 [0][1] [8][-1][-1] Not Configured = for ISDN spans, the progress
indicator (PI) that is received in ISDN Proceeding, Progress and Alert
messages is used as described in the options below (default).
 [0] No PI = For IP-to-Tel call, the gateway sends 180 Ringing SIP
response to IP after receiving ISDN Alert or (for CAS) after placing a
call to PBX/PSTN.
 [1] PI =1, [8] PI =8: For IP-to-Tel call, if EnableEarlyMedia = 1, the
gateway sends 180 Ringing with SDP in response to an ISDN alert,
or it sends a '183 session in progress' message with SDP in response
to only the first received ISDN Proceeding or Progress message,
after a call is placed to PBX/PSTN over the trunk.
To Next Page
Loading...
Need help?
General