SIP User's Manual 310 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
Table 6-10: PSTN Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
ISDN Flexible Behavior Parameters
ISDN protocol is implemented in different Switches / PBXs by different vendors. Several
implementations vary a little from the specification. Therefore, to provide a flexible interface that
supports these ISDN variants, the ISDN behavior parameters are used.
ISDNInCallsBehavior
For a description of this parameter, refer to 'Trunk Settings' on page 178.
ISDNIBehavior
For a description of this parameter, refer to 'Trunk Settings' on page 178.
ISDNGeneralCCBehavior
For a description of this parameter, refer to 'Trunk Settings' on page 178.
ISDNOutCallsBehavior
For a description of this parameter, refer to 'Trunk Settings' on page 178.
ISDNIBehavior_x
Same as the description for parameter ISDNIBehavior, but for a specific
trunk ID.
ISDNInCallsBehavior_x
Same as the description for parameter ISDNInCallsBehavior, for a
specific trunk ID.
ISDNOutCallsBehavior_x
Same as the description for parameter ISDNOutCallsBehavior, but for a
specific trunk ID.
PlayRBTone2Tel
For a description of this parameter, refer to 'General Parameters' on
page 72.
PlayRBTone2IP
For a description of this parameter, refer to 'General Parameters' on
page 72.
ProgressIndicator2IP
For a description of this parameter, refer to 'General Parameters' on
page 103.
SendMetering2IP
This parameter is now obsolete.
TimeForReorderTone
Busy or Reorder Tone duration the CAS gateway plays before releasing
the line.
The valid range is 0 to 15. The default value is 10 seconds.
Applicable also to ISDN if PlayBusyTone2ISDN = 2. Selection of Busy or
Reorder tone is done according to release cause received from IP.
DisconnectOnBusyTone
For a description of this parameter, refer to 'Configuring the Digital
Gateway Parameters' on page 142.
EnableVoiceDetection
 [1] = The gatewaysends 200 OK (to INVITE) messages when
speech/fax/modem is detected.
 [0] = The gateway sends 200 OK messages immediately after the
gateway finishes dialing (default).
Usually this feature is used only when early media is used to establish
voice path before the call is answered.
Notes:
 To activate this feature, set EnableDSPIPMDetectors to 1.
 This feature is applicable only when the protocol type is CAS.
DigitMapping
For a description of this parameter, refer to 'DTMF & Dialing Parameters'
on page 99.
To Next Page
Loading...
Need help?
General