EasyManuals Logo

AudioCodes Mediant 2000 System User Manual

AudioCodes Mediant 2000 System
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #313 background imageLoading...
Page #313 background image
Version 5.2 313 September 2007
SIP User's Manual 6. ini File Configuration
Table 6-11: ISDN and CAS Interworking-Related Parameters
ini File Field Name
Web Parameter
Name
Valid Range and Description
SITQ850Cause
Determines the Q.850 cause value specified in the Reason header that is
included in a 4xx response when Special Information Tone (SIT) is detected
on an IP-to-Tel call.
The valid range is 0 to 127. The default value is 34.
UserToUserHeaderF
ormat
Determines the format of the User-to-User header.
 [0] = X-UserToUser (default)
 [1] = User-to-User
RemoveCLIWhenRe
stricted
For a description of this parameter, refer to 'Configuring the Digital Gateway
Parameters' on page 142.
ScreeningInd2ISDN
For a description of this parameter, refer to 'Configuring the Digital Gateway
Parameters' on page 142.
ProgressIndicator2I
SDN_ID
For a description of this parameter, refer to 'Trunk Settings' on page 178.
PIForDisconnectMs
g_ID
For a description of this parameter, refer to 'Trunk Settings' on page 178.
ConnectOnProgress
Ind
 [0] = Connect message isn't sent after 183 Session Progress is received
(default).
 [1] = Connect message is sent after 183 Session Progress is received.
This feature enables the play of announcements from IP to PSTN without the
need to answer the Tel-to-IP call. It can be used with PSTN networks that
don't support the opening of a TDM channel before an ISDN Connect
message is received.
SIP183Behavior
For a description of this parameter, refer to 'General Parameters' on page 72.
LocalISDNRBSource
_ID
For a description of this parameter, refer to 'Trunk Settings' on page 178.
PSTNAlertTimeout
For a description of this parameter, refer to 'General Parameters' on page
103.
TrunkPSTNAlertTim
eout_ID
For a description of this parameter, refer to 'Trunk Settings' on page 178.
ISDNTransferCapabi
lity_ID
For a description of this parameter, refer to 'Trunk Settings' on page 178.
SendISDNTransferO
nConnect
For a description of this parameter, refer to 'Configuring the Digital Gateway
Parameters' on page 142.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant 2000 System and is the answer not in the manual?

AudioCodes Mediant 2000 System Specifications

General IconGeneral
BrandAudioCodes
ModelMediant 2000 System
CategoryVoIP
LanguageEnglish