Version 5.2 319 September 2007
SIP User's Manual 6. ini File Configuration
Table 6-12: Number Manipulation and Routing Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
TrunkGroupSettings
Defines rules for port allocation for specific Trunk Groups. If no rule
exists, the global rule defined by ChannelSelectMode applies.
Format for this ini file table parameter:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName;
[\TrunkGroupSettings]
Where,
 TrunkGroupID = Trunk Group ID number.
 ChannelSelectMode = Channel select mode for the Trunk Group.
Available values are identical to those defined by the
ChannelSelectMode parameter.
 RegistrationMode = Registration mode for the Trunk Group (Per
Endpoint [0], Per Gateway [1], or Do Not Register [4]). If not
configured [-1], the value of AuthenticationMode is used.
 GatewayName = ‘sipgatewayname’ used as a hostname in the From
header in INVITE and REGISTER messages. If not configured, the
‘sipgatewayname’ parameter is used.
For example:
[TrunkGroupSettings]
TrunkGroupSettings 0 = 9,0,0,$$;
[\TrunkGroupSettings]
For a description on ini file parameter tables, refer to 'Structure of ini
File Parameter Tables' on page 269.
For configuring Trunk group settings using the Embedded Web Server,
refer to Configuring Trunk Group Settings on page 140.
AddTrunkGroupAsPrefix
For a description of this parameter, refer to 'General Parameters' on
page 120.
AddPortAsPrefix
For a description of this parameter, refer to 'General Parameters' on
page 120.
ReplaceEmptyDstWithPor
tNumber
For a description of this parameter, refer to 'General Parameters' on
page 120.
CopyDestOnEmptySource

[0] = Leave Source Number empty (default).
 [1] = If the Source Number of an incoming Tel to IP call is empty, the
Destination Number is copied to the Source Number.
AddNPIandTON2CallingN
umber
For a description of this parameter, refer to 'General Parameters' on
page 120.
AddNPIandTON2CalledNu
mber
For a description of this parameter, refer to 'General Parameters' on
page 120.
UseSourceNumberAsDisp
layName
For a description of this parameter, refer to 'General Parameters' on
page 120.
To Next Page
Loading...
Need help?
General