SIP User's Manual 336 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
Table 6-13: Channel Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
DTMFGenerationTwist
For a description of this parameter, refer to 'Configuring the Voice
Settings' on page 166.
DTMFInterDigitInterval
Time in msec between generated DTMF digits to PSTN side (if
TxDTMFOption = 1, 2 or 3).
The default value is 100 msec. The valid range is 0 to 32767.
DTMFDigitLength
Time in msec for generating DTMF tones to the PSTN side (if
TxDTMFOption = 1, 2 or 3).
The default value is 100 msec. The valid range is 0 to 32767.
RxDTMFHangOverTime
Defines the Voice Silence time (in msec units) after playing DTMF
or MF digits to the Tel / PSTN side that arrive as Relay from the IP
side.
Valid range is 0 to 2,000 msec. The default is 1,000 msec.
TxDTMFHangOverTime
Defines the Voice Silence time (in msec units) after detecting the
end of DTMF or MF digits at the Tel / PSTN side when the DTMF
Transport Type is either Relay or Mute.
Valid range is 0 to 2,000 msec. The default is 100 msec.
DTMFTransportType
For a description of this parameter, refert o 'Configuring the Voice
Settings' on page 166.
RFC2833PayloadType
For a description of this parameter, refer to 'DTMF & Dialing
Parameters' on page 99.
UDTDetectorFrequencyDeviati
on
Defines the deviation (in Hz) allowed for the detection of each
signal frequency. Units are in Hertz.
The valid range is 1 to 50. The default value is 50 Hz.
CPTDetectorFrequencyDeviati
on
Defines the deviation (in Hz) allowed for the detection of each CPT
signal frequency.
The valid range is 1 to 30. The default value is 10 Hz.
MGCPDTMFDetectionPoint
[0] = DTMF event is reported on the end of a detected DTMF
digit.
[1] = DTMF event is reported on the start of a detected DTMF
digit (default).
VQMonEnable
For a description of this parameter, refer to 'Configuring the RTP /
RTCP Settings' on page 172.
RTCPInterval
For a description of this parameter, refer to 'Configuring the RTP /
RTCP Settings' on page 172.
DisableRTCPRandomize
For a description of this parameter, refer to 'Configuring the RTP /
RTCP Settings' on page 172.
RTCPXREscIP
For a description of this parameter, refer to 'Configuring the RTP /
RTCP Settings' on page 172.
RTCPXRReportMode
For a description of this parameter, refer to 'Configuring the RTP /
RTCP Settings' on page 172.
To Next Page
Loading...