Version 5.2 53 September 2007
SIP User's Manual 4. Getting Started
4.3.3.2 Assigning an IP Address
Once you have accessed the CLI, follow the procedure below for assigning a new IP
address.
¾ To assign an IP address via the CLI, take these 4 steps:
1. At the prompt, type conf, and then press <Enter>; the configuration folder is
accessed.
2. To view the current network parameters, at the prompt, type GCP IP, and then press
<Enter>; the current network settings are displayed.
3. Change the network settings by typing the following:
SCP IP [ip_address] [subnet_mask] [default_gateway]
For example,
SCP IP 10.13.77.7 255.255.0.0 10.13.0.1
The new settings take effect on-the-fly. Connectivity is active at the new IP address.
Note: This command requires you to enter all three network parameters (each
separated by a space).
4. To save the configuration, at the prompt, type SAR, and then press <Enter>; the
gateway restarts with the new network settings.
To Next Page
Loading...
Need help?
General