auer HRC70 - Resetting Installer Parametres 205 to 230; Forced Command of the System

- INSTALLER 7 & 11kW HRC
70
HIGH TEMPERATURE HEAT PUMP -
30
Enter Enter
• Press "yes" to stop the installation.
Turn the dial towards
(+) and the screen will
display "yes"
Press
to return to "iNSt. MENU" screen.
4.2.3.5 - Resetting installer parametres 205 to
230
r e s e t p a r.
r e s e t p a r.
no
Accessing the Installer Menu:
• Press
• Turn the dial until the screen displays "INST. Menu"
• Press
and at the same time
• Keep them held down simultaneously for 3 sec.
Enter
Enter
Enter
Enter Enter
Enter
m a n u a l
ba c k up 1
ba c k up 2
ba c k up 3
c i r c . HP c i r c . c1
c i r c . c2
Accessing the Installer Menu:
• Press
• Turn the dial until the screen displays
"INST. MENU"
• Press
and at the same time
• Keep them held down simutaneously for 3 sec.
In order to diagnose errors occurring on Heat Pump components,
certain elements can be manually engaged on a temporary basis.
4.2.4 - Forced command of the system
Electrical back-up n°1
Electrical back-up n°2
Electrical back-up n°3
Heat Pump
circulator pump
Heating circuit 1
circulator pump
Heating circuit 2
circulator pump