auer HRC70 - Delivery Terms and Conditions; Storage and Transport; General Information; Transporting with a Forklift Truck

- INSTALLER 7 & 11kW HRC
70
HIGH TEMPERATURE HEAT PUMP MANUAL -
5
1.4.3 - Transporting manually
The Heat Pump can be transported manually.
Do not damage the heat exchanger fins
during handling or transport.
Heat Pumps should never be laid on their
sides. Do not tilt the appliance more than 30°.
The Heat Pump uses type R290 refrigerant. Given the fl ammable
nature of this fl uid, any work done on the refrigerant circuit must
be carried out using the correct equipment and in compliance
with all current regulations. In case of handling the fl uid (recovery,
evacuation or refi lling), the machine must be switched off . Do not
smoke or light any fl ame ( e.g. lighter, blowtorch) when handling the
fl uid. If any work needs to be undertaken on the refrigerant circuit
using a fl ame (e.g. a blowtorch)
the refrigerant must be evacuated
fi rst and replaced with nitrogen.
1.3 - Delivery terms and conditions
In general, the material is transported at the recipient’s own risk.
It is essential to check that all the elements have been received
and that no damage has been sustained during transport upon
receipt of the appliance and before beginning the installation
procedure.
Heat Pump
Accessories
Pilot
1.4 - Storage and transport
Acceptable transport temperatures range from -20°C to +60°C.
1.4.1 - General information
1.4.2 - Transporting with a forklift truck
The appliances must be stored and transported in their
packaging on a wooden pallet and completely empty of water.
When being transported by a forklift truck, the Heat Pump must
remain upright on a wooden pallet.
When moving the Heat Pump do not lift or lower the unit suddenly
as it can easily lose its balance. It should also be suitably secured to
prevent it from tipping over.