auer HRC70 - A5.1 - Creating a New Programme; A5.2 - Copying Existing Programmes

- INSTALLER 7 & 11kW HRC
70
HIGH TEMPERATURE HEAT PUMP -
56
Con rm end time of 1
st
programmed time
period
Con rm end time of 2
nd
programmed time
period
Con rm "COMF" mode
Con rm end time of 3
rd
programmed time
period
Con rm "ECO" mode
Con rm "ECO" mode
Programmes can be created at 15-minute intervals up to 7 times
in 24 hours. For example, the following programme could be
created for a Monday:
The screen displays
00:00h (at the bottom)
• Turn the dial to 06:30h
The screen displays "COMF"
(comfort)
• Turn dial, to the left, to "ECO"
The screen displays
"COMF"(comfort)
• Turn dial to the left to "ECO"
A message appears to con rm
the programming for Monday.
After 1sec, it will switch to the
following day.
The screen displays the next
day
Start programming for
Tuesday
• Turn dial to 09:45h
• The screen displays "COMF"
(comfort)
• Turn dial to18:30h
A5.1 - Creating a new programme
0000 - ____
00:00
0000 - 0630
ECO
0630 - ____
06:30
0630 - 0945
COmF
0945 - ____
18:30
0945 - 1830
Frost PT.
1830 > ____
18:30
Con rm "FROST PT." mode
The screen displays "COMF"
(comfort)
• Turn dial to the left, to "FROST
PT." (frost protection mode)
The screen displays 18:30 (end
time = start time)
Con rm end time of 4
th
programmed time
period
1830 - 2400
ECO
ok tuesday
tuesday
• Press to con rm and quit programming heating modes.
• Con rm to copy Tuesday’s
programme
• Turn dial to select either:
- another pre-recorded programme, PR1 to PR4
(see next page)
- a programme created previously for another
day
A5.2 - Copying existing programmes
COPy TUEs.
COPy PR.
The  rst programme, which will be suggested by default,
will be the programme from the day before. The dial enables
you to access programmes from other days, or pre-recorded
programmes.
For example, for a Wednesday:
COMFORT
FROST PT.