auer HRC70 - Situations Anormales, Sans Code Derreur ni Alarme

- INSTALLER 7 & 11kW HRC
70
HIGH TEMPERATURE HEAT PUMP -
40
6.6 - Problems which are not indicated by alarm or error code
Error not displayed on
screen
Possible causes Solutions
request
PAR.209 and 215
and switch to winter mode then auto
to the Pilot and the power supply
correctly
that there is voltage and the values: compressor
start-up is prevented if if voltage is too high or too
low)
up
the fan and other electrical components (e.g. the
circulator pump)
allow motor start-up: install a D-curve circuit
breaker
requirements
engage properly
PAR.217 and 218
properly: it must be correctly configured.
reading
safety device
authorised range
The Heat Pump will not start
up
The Heat Pump starts up but
does not produce enough
heat