DL205 User Manual, 4th Edition, Rev. B
5–71
Chapter 5: Standard RLL Instructions - Logical
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Logical Instructions (Accumulator)
And (AND)
The And instruction is a 16-bit instruction that logically ANDs
the value in the lower 16 bits of the accumulator with a
specified V-memory location (Aaaa). The result resides in the
accumulator. The discrete status flag indicates if the result of the
And is zero.
NOTE: The status flags are only valid until another instruction that uses the same flags is executed.
In the following example, when X1 is on, the value in V2000 will be loaded into the
accumulator using the Load instruction. The value in the accumulator is anded with the value
in V2006 using the And instruction. The value in the lower 16 bits of the accumulator is
output to V2010 using the Out instruction.
Discrete Bit Flags Description
SP63 on when the result of the instruction causes the value in the accumulator to be zero.
AND (V2006)
Handheld Programmer Keystrokes
LD
V2000
X1
Load the value in V2000 into
the lower 16 bits of the
accumulator
AND
V2006
AND the value in the
accumulator with
the value in V2006
OUT
V2010
Copy the lower 16 bits of the
accumulator to V2010
0010100001111010
00101000001110000000010000000000
V2000
287A?
0000000000000000
0000000000000000
The upper 16 bits of the accumulator
will be set to 0
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 1631 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Acc.
Acc.
00101000011110100000000000000000
Acc.
01101010001110000000000000000000
6A38
V2010
2838
DirectSOFT
STR
$
SHFT
ANDST
L
3
D
SHFT
AND
V
2
C
0
A
0
A
ENT
6
G
OUT
GX
SHFT
AND
V
2
C
0
A
1
B
0
A
ENT
AND
V
1
B
ENT
2
C
0
A
0
A
0
A
ENT
Operand Data Type DL230 Range DL240 Range DL250-1 Range DL260 Range
A aaa aaa aaa aaa
V-memory V
All. See
memory map
All. See
memory map
All. See
memory map
All. See
memory map
Pointer P -
All V-memory.
See memory map
All V-memory.
See memory map
All V-memory.
See memory map
DS Used
HPP Used