Automationdirect.com DirectLOGIC DL205 Series User Manual

DL205 User Manual, 4th Edition, Rev. B
5–177
Chapter 5: Standard RLL Instructions - CPU Control
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
CPU Control Instructions
No Operation (NOP)
The No Operation is an empty (not programmed) memory location.
End (END)
The End instruction marks the termination point of the normal
program scan. An End instruction is required at the end of the main
program body. If the End instruction is omitted an error will occur and
the CPU will not enter the Run Mode. Data labels, subroutines and
interrupt routines are placed after the End instruction. The End
instruction is not conditional; therefore, no input contact is allowed.
Stop (STOP)
The Stop instruction changes the operational mode of the CPU from
Run to Program (Stop) mode. This instruction is typically used to stop
PLC operation in a shutdown condition such as a I/O module failure.
In the following example, when SP45 comes on indicating a I/O module failure, the CPU
will stop operation and switch to the program mode.
NOP
þ
þ
þ
þ
230
240
250-1
260
DirectSOFT
Handheld Programmer Keystrokes
NOP
SHFT
TMR
N
INST#
O
CV
P
ENT
END
þ
þ
þ
þ
230
240
250-1
260
DirectSOFT
Handheld Programmer Keystrokes
END
SHFT
4
E
TMR
N
3
D
ENT
STOP
þ
þ
þ
þ
230
240
250-1
260
DirectSOFT
Handheld Programmer Keystrokes
STOP
SP45
STR
$
SHFT ENT
STRN
SP
4
E
SHFT
RST
S
MLR
T
INST#
O
CV
P
ENTSHFT
5
F
SP45 will turn on
if there is an I/O
module failure.
DS Used
HPP Used
DS Used
HPP Used
DS Used
HPP Used

Automationdirect.com DirectLOGIC DL205 Series Specifications

General

Brand	Automationdirect.com
Model	DirectLOGIC DL205 Series
Category	Controller
Language	English