Automationdirect.com DirectLOGIC DL205 Series User Manual

CPU Hardware Setup
Communication Port Pinout Diagrams
Cables are available that allow you to quickly and easily connect a Handheld Programmer or a
personal computer to the DL205 CPUs. However, if you need to build a cable(s), use the
pinout descriptions shown on the following pages. You can also use the Tech Support/Cable
Wiring diagrams located on our website.
The DL240, DL250–1 and DL260 CPUs have two ports while the DL230 has only one. All
of the CPUs require at least one RJ-12 connector. The DL250-1 and DL260 require one 15
pin D-shell connector.
DL205 User Manual, 4th Edition, Rev. B
3–6
Chapter 3: CPU Specifications and Operations
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
RJ12 Phone Jack
RS-232, 9600 baud
Communication Port
–K-sequence
–Direct NET slave
–Modbus RTU slave
–easily connect
DirectSOFT,
handhelds, operator
interfaces, any DirectNet
master
Port 1
DL250–1 and DL260
Port 2
Additional DL260 Features
CH1
CH2
CH3
CH4
RUN
TERM
RUN
CPU
PWR
BATT
PORT 1
PORT 2
DL240
CPU
RUN
PWR
BATT
PORT 1?
CPU
RJ12 Phone Jack
RS-232, 9600 baud
Communication Port
–K-sequence
–easily connect
Direct SOFT, handhelds,
operator interfaces, etc.
Port 1
RJ12 Phone Jack
RS-232, up to 19.2K baud
Communication Port
–K-sequence
–Direct NET slave
–easily connect
DirectSOFT, handhelds,
operator interfaces, or any
DirectNet master
Port 2
15-pin HD Connector
RS-232/RS-422, up to 38.4K baud
Communication Port
–K-sequence
–Direct NET Master/Slave
–Modbus RTU Master/Slave
–easily connect
Direct SOFT,
handhelds, operator
interfaces, any DirectNet
or Modbus master or slave
DL260
Port 2
DL250–1 and DL260
–ASCII IN/OUT Instructions
–Extended Modbus Instructions
–RS-485 support
CPU
DL230

Automationdirect.com DirectLOGIC DL205 Series Specifications

General

Brand	Automationdirect.com
Model	DirectLOGIC DL205 Series
Category	Controller
Language	English