Avaya 1230 - Connecting the LAN Ethernet Cable; Connecting the PC Ethernet Cable

1. Connect the DC barrel connector to the power jack on the back of the IP
Deskphone.
2. Thread the cable through the channel in the foot stand (if installed) to secure the
cable.
3.
Plug the country-specific IEC cable into the Global Power Supply, and then plug the
Global Power Supply into the nearest AC power outlet.
Connecting the LAN ethernet cable
Connect your IP Deskphone to your LAN using a CAT5e Ethernet cable to enable full
functionality of
your IP Deskphone. If your Ethernet port is equipped with Power over Ethernet
(PoE), your Avaya 1230 IP Deskphone can be powered through the LAN port. Do not extend
the LAN Ethernet cable outside the building.
To connect your IP Deskphone to your LAN use the following procedure:
1. Plug one end of the supplied LAN Ethernet cable into the LAN Ethernet port on the
back of your IP Deskphone as shown in
IP Deskphone Connections on page 50.
2. Thread the cable through the channel in the foot stand (if installed).
3. Connect the other end of the cable to your LAN Ethernet connection. The LAN LED
on the back of the IP Deskphone lights when a LAN connection is established.
Note:
When your
LAN cable gets unplugged on an active IP Deskphone, your IP Deskphone LCD
displays an alert message LAN cable unplugged.
Connecting the PC Ethernet cable
Connect a CAT5e PC Ethernet cable between your Avaya 1230 IP Deskphone and your
computer to enable your computer to access the LAN.
1. Plug one end of the PC Ethernet cable (not supplied) into the PC Ethernet port on
the back of your Avaya 1230 IP Deskphone as shown in
IP Deskphone
connections on page 50.
2.
Thread the cable through the channel in the foot stand (if installed).
3. Connect the other end of the cable to the LAN port on your PC.
Installing the 1230 IP Deskphone
52 Avaya 1230 IP Deskphone with SIP Software User Guide November 2013
Comments? infodev@avaya.com