Important:
IPv6 operation is limited to a specific customer set and is not available for general use.
Note:
You can use the ADDR option to view IP addresses if needed. The IP addresses might have
been entered incorrectly. Verify whether you were provided with correct IP addresses.
Procedure
1. Select VIEW from the Craft Local Procedure Screen.
The phone displays the following options: IP Parameters, Quality of Service, and
Miscellaneous.
2. Tap the category that you want to see.
The information for that category is displayed.
Note:
Use the Right navigation arrow to scroll through the viewable information. For more
information on system parameters, see
Table 1 Parameter Values on page 71.
Table 2: Parameter Values
Name System Value Format
Phone (IPv4) nnn.nnn.nnn.nnn Phone IP address, IPADD value.
Phone (IPv6) hhhh:hhhh::hhhh:hhhh:hhhh Phone IP address, NVIPADDV6
value.
Phone (IPv6LL) hhhh:hhhh::hhhh:hhhh:hhhh Phone IP address, IPADDV6LL
value.
Call Server nnn.nnn.nnn.nnn IP address of the call server
currently in use, otherwise 0.0.0.0.
Supplicant ccccccccccccccccc Text equivalent of DOT1XSTAT. If
0, Disabled; if 1, Unicast-only; if 2,
Unicast/multicast.
Pass-thru ccccccccccccccccc Text equivalent of DOT1X. If 0,
Enabled; if 1, Enabled w/Logoff; if
2, Disabled.
Router (IPv4) nnn.nnn.nnn.nnn Up to 15 ASCII characters, the IP
address of the router in use.
Mask (IPv4) nnn.nnn.nnn.nnn Up to 15 ASCII characters,
NETMASK value.
HTTP server nnn.nnn.nnn.nnn IP address of last HTTP server
used successfully during
initialization or 0.0.0.0. if no file
server was used successfully.
Table continues…
Troubleshooting
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 71
Comments on this document? infodev@avaya.com
To Next Page
Loading...
